VERITAS NetBackup 5330 Configuration Manual page 42

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console
Deduplication Disk (MSDP)
After you have entered all of the necessary information, click Next.
14
On the Configuration Progress page, you can monitor the progress of the
appliance as it applies all of the data input from the configuration pages.
The amount of time for the configuration to complete varies and depends on
the complexity of your environment.
15
On the Summary of Configuration page, review the results of the
configuration. Examine the results to make sure that the configuration completed
successfully.
This page also identifies any errors that may have occurred. You may need to
perform the initial configuration again if errors appear in the results.
16
After the configuration has completed successfully, wait about 10 minutes for
the NetBackup services to start. You must then use the fully qualified host
name to reconnect and log into the appliance.
17
Change the default
Enter the following information:
Storage Unit Name
■
Enter the name that you want to use to identify this
storage unit. The name can contain any letters,
numbers, or special characters. The name can
include up to 256 characters.
Note:
The name should not start with the minus (-)
character and spaces should not be used anywhere
in the name.
Disk Pool Name
■
Enter the name that you want to use to identify this
disk pool. The name can contain any letters,
numbers, or special characters. The name can
include up to 256 characters.
Note:
The name should not start with the minus (-)
character and spaces should not be used anywhere
in the name.
Size
■
Set the size for this partition by entering a precise
number in the Size field, or click and drag the box
on the gray slide bar to the desired size. The size
can be set in GB or TB units, depending on the
maximum available space.
user password as follows:
Maintenance
Initial configuration procedures 42