Table of Contents
Advertisement
Adding the disk space of additional Veritas Storage Shelf units to an operational NetBackup 52xx appliance
Adding the disk space of additional Veritas
Storage Shelf units to an operational NetBackup
52xx appliance from the NetBackup Appliance
Web Console
The following procedure describes how to add new storage shelf disk space to a
NetBackup appliance using the NetBackup Appliance Web Console.
To add new storage shelf disk space to a NetBackup appliance using the
NetBackup Appliance Web Console
1
Launch the NetBackup Appliance Web Console and verify that the new storage
devices appear on the Monitor > Hardware page. If the new storage devices
do not appear, check the cable connections and make sure that the power is
on.
2
Click Manage > Storage.
3
Select the Disks tab.
4
Click the Click here to scan for new disks option.
5
In the Do you want to scan for new disk? dialog box, click OK to start the
scan.
6
When the scan is complete, click OK to refresh the Disk tab.
In the Disk column, a new ID should appear for the new storage shelf units.
The new entries should have the following attributes:
Type = Expansion.
■
Status = New Available
■
7
In the Status column, next to New Available, click Add to activate the storage
in the RAID.
8
In the Confirmation dialog box, click Yes to start a scan.
When the process completes, the following message should appear:
Storage operation completed. Succeeded.
9
Click OK to refresh the system.
After the system refreshes, the Disks tab should show the following attributes
for the new storage shelf units:
Type = Expansion
■
Status = In Use
■
Adding storage shelves
from the NetBackup Appliance Web Console
61
Advertisement
Table of Contents
