VERITAS NetBackup 5330 Configuration Manual page 40

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console
12
On the Specify Master Server page, enter the name of the master server that
you plan to use with this media server as follows:
For master servers with only one name and IP address:
■
Enter the host name or the IP address of the master server and click Add.
For clustered master servers or master servers with multiple names and
■
IP addresses:
Enter the first host name or IP address in the field and click Add. If the
master server is clustered, the first entry must be the virtual host name of
the cluster.
Enter each additional host name or IP address in the same manner (one
at a time), and click Add after each entry.
Note: If the host name of the master server is an FQDN, Veritas
recommends that you use the FQDN to specify the master server for the
media server.
After you have entered all of the necessary information, click Next.
■
Note: After you complete the role configuration, the storage initialization starts.
Depending on the number of disk drives in the system, the storage initialization
can take up to 46 hours to complete. As a result, appliance backup and restore
performance is degraded until the storage initialization process has completed.
13
On the Storage Configuration page, create names for the storage units and
the disk pools that you plan to use, and configure the size of the disk partitions.
You can configure storage partitions for AdvancedDisk, for Deduplication
(MSDP), or for both.
Note: If you choose to configure MSDP storage, a policy is automatically
created to protect the MSDP catalog. Veritas recommends reviewing this policy
and activating it once your appliance is configured.
Initial configuration procedures 40