Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Shell Menu
4
Before you begin the initial configuration, check and verify the status of the
connected hardware components by entering the following command:
Support > Test Hardware
A Warning indicates a problem that can be fixed later and lets you proceed
with the initial configuration. However, such problems can prevent access to
the affected devices.
An Error indicates a critical problem that requires immediate resolution before
you can proceed with the initial configuration.
If the command output identifies any problems, check the following items:
Verify that all cables are connected correctly and secured.
■
Verify that all disk drives are installed and seated properly.
■
Verify that all units are turned on and have booted up completely.
■
Verify that you have checked all of the items on the hardware check list.
■
After you have verified the previous items, re-run the command. Any warning
■
or error icons that disappear indicate that the problem has been fixed.
Veritas recommends that you resolve all problems before you start the initial
configuration.
Note: If you cannot resolve any Error problems after verifying all of the previous
items and re-running the command, stop here and contact Veritas Technical
Support.
Initial configuration procedures
46