VERITAS NetBackup 5330 Configuration Manual page 29

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console
For the IP address, enter
■
from 2 through 254 except for 233.
For the Subnet mask, enter 255.255.255.0.
■
Click OK.
■
2
On the laptop that is connected to the appliance, open a web browser to the
following URL:
http://192.168.229.233
Make sure to confirm the security exception to proceed.
3
Log on to the appliance with the default credentials as follows:
User Name: admin
■
Password: P@ssw0rd
■
4
On the Welcome to Appliance Setup page, review the summary of information
that you need to perform the initial configuration.
Download Configuration Checklist
■
If you have not previously filled out the checklist in the NetBackup 5330
Initial Configuration Guide, click this link to access an electronic version.
Veritas recommends that you first print this file, then fill it out for use as you
perform the configuration. After you have completed the initial configuration,
store the checklist in a secure location for future reference.
Setup Appliance
■
After you have filled out the configuration checklist, click this item to start
the configuration.
5
On the Storage Overview page, check and verify the status of the connected
hardware components.
The diagrams use specific icons to indicate whether any component cable or
disk drive problems exist. The following describes the general icons that may
appear:
Note: Click the help (?) icon at the top right of the page to see a complete list
of icon descriptions.
Initial configuration procedures
, where
192.168.229.nnn
OK
is any number
nnn
29