VERITAS NetBackup 5330 Configuration Manual page 30

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console
If there are no problems identified, click Next to start the initial configuration.
Otherwise, use the following guidelines to resolve any problems:
Click on the warning or the error icon to see a description of the problem.
■
Verify that all cables are connected correctly and secured.
■
Verify that all disk drives are installed and seated properly.
■
Verify that all units are turned on and have booted up completely.
■
Verify that you have checked all of the items on the hardware check list.
■
After you have verified the previous items or made any changes, click
■
Refresh. Any warning or error icons that disappear indicate that the problem
has been fixed.
Veritas recommends that you resolve all problems before you start the initial
configuration.
Note: If you cannot resolve any error problems after verifying all of the previous
items and refreshing, stop here and contact Veritas Technical Support.
6
The Network Configuration page contains the following taskbars to complete
specific tasks with the associated data entry fields to configure network
connectivity:
Initial configuration procedures
Warning
Indicates a problem that can be
fixed later and lets you proceed
with the initial configuration.
However, such problems can
prevent access to the affected
devices. Click the icon to see a
description of the problem.
Error
Indicates a critical problem that
requires immediate resolution
before you can proceed with the
initial configuration. Click the icon
to see a description of the
problem.
Information
Click the icon to learn more about
the specific area.
30