Performing The Initial Configuration On A Netbackup 5330 Appliance From The Netbackup Appliance Web Console - VERITAS NetBackup 5330 Configuration Manual

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console

Performing the initial configuration on a
NetBackup 5330 appliance from the NetBackup
Appliance Web Console
This topic describes how to configure a NetBackup 5330 appliance that is new or
has been reset to the factory defaults (factory reset).
This method requires that you connect a laptop directly to appliance port NIC1
(eth0). A NetBackup 5330 appliance can only be configured as a media server.
Before you perform the initial configuration on this media server, verify that you
have already performed the following tasks:
Verified that the master server and this media server have compatible software
■
versions.
Added the host name of this media server to the
■
server that you plan to use with it.
See "Configuring a master server to communicate with an appliance media
server" on page 26.
Opened the appropriate ports on the master server if a firewall exists between
■
the master server and this media server.
See "Configuring a master server to communicate with an appliance media
server" on page 26.
Completed the initial configuration checklist.
■
Caution: The appliance comes configured with a known default password for the
user account. You should change this password either before or
Maintenance
immediately after the initial configuration to prevent unauthorized access to the
appliance maintenance mode. Note that you must provide the
password to Veritas Technical Support in the event that the appliance requires
troubleshooting services. Step
change the
Maintenance
To perform the initial configuration on a NetBackup 5330 media server
appliance from the NetBackup Appliance Web Console
1
Connect a laptop to appliance port NIC1. Next, navigate to the Local Area
Connection Properties dialog box.
On the General tab, select Internet Protocol (TCP/IP) so that it is highlighted,
then click Properties.
17 in the following procedure describes how to
user password.
Initial configuration procedures
list on the master
SERVERS
Maintenance
27
user