Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Shell Menu
With this step, NetBackup is re-configured to operate with the new host name.
This process may take a while to complete.
For the command
For example, you may want to set the host name of a specific host to v46. To
do that, first ensure that the specific host has at least an IPv4 address and
then run the following command.
Main_Menu > Network > Hostname set v46
11
In addition to the above network configuration settings, you may also use the
Main_Menu > Network view to create a bond and to tag a VLAN during the
initial configuration of your appliance.
To create a bond between two or more network interfaces, use the following
■
command:
Network > LinkAggregation Create
To tag a VLAN to a physical interface or bond interface, enter the following
■
command:
Network > VLAN Tag
For detailed information about the
options, refer to the NetBackup Appliance Command Reference Guide.
12
From the Main_Menu > Network view, use the following commands to set the
time zone, the date, and the time for this appliance:
Set the time zone by entering the following command:
■
TimeZone Set
Select the appropriate time zone from the displayed list.
Set the date and the time by entering the following command:
■
Date Set Month Day HHMMSS Year
Where Month is the name of the month.
Where Day is the day of the month from 0 to 31.
Where HHMMSS is the hour, minute, and seconds in a 24-hour format.
The fields are separated by semi-colons (HH:MM:SS).
Where Year is the calendar year from 1970 through 2037.
to work, at least one IPv4 address is required.
Hostname set
LinkAggregation
Initial configuration procedures
and the
command
VLAN
50