VERITAS NetBackup 5330 Configuration Manual page 34

Performing the initial configuration on a NetBackup 5330 appliance from the NetBackup Appliance Web Console
Add the IP address, the fully qualified host name, and the short host name
directly into the
/etc/hosts
file.
file
Enter the appliance host name and the related host resolution information
■
in the following fields:
Host Name Enter the fully qualified domain name (FQDN) of this appliance.
Enter the short host name or the fully qualified domain name
(FQDN) of this appliance.
The host name is applied to the entire appliance configuration with
a few exceptions. The short name always appears in the following
places:
■
■
■
If this appliance has been factory reset and you want to import
any of its previous backup images, the appliance host name must
meet one of the following rules:
■
■
■
Note:
session. After the initial configuration has completed successfully,
you can re-enter initial configuration by performing a factory reset
on the appliance. See the NetBackup Appliance Administrator's
Guide for more information.
file. Click here to open and edit the
NetBackup Appliance Shell Menu prompts
Deduplication pool catalog backup policy
Default storage unit and disk pool names
The host name must be exactly the same as the one used
before the factory reset.
If you want to change the host name to an FQDN, it must
include the short name that was used before the factory reset.
For example, if "myhost" was used before the factory reset,
use "myhost.domainname.com" as the new FQDN.
If you want to change the host name to a short host name, it
must be derived from the FQDN that was used before the
factory reset. For example, if "myhost.domainname.com" was
used before the factory reset, use "myhost" as the new short
host name.
The host name can only be set during an initial configuration
Initial configuration procedures
/etc/hosts
34