SciCan STATIM 2000 Service Manual page 52

3. Troubleshooting Cycle Faults
NOTE: For some functions (depending on the function of the sub menu), pressing the "Stop"
button may NOT save the changes. When changes made to unit values are NOT saved after
pressing the STOP button and the unit returns to the service menu, always select SAVE AND
EXIT if you wish to save any new values.
Sub Menu items (Activated by the "Rubber and Plastics" button when the cursor ">" is next to the
description):
>Calibration
This will display the calibration screen relevant to the specific revision 7 unit and allow you to
perform calibration operations. For calibration information, refer to calibration procedure 4 in
Chapter 4 of this manual (non S class) or calibration procedure 7 in Chapter 5 of this manual
(S class).
>Time/Date Setup
There are 5 selectable items (fields), hours, minutes, date, month and year. After entering the
menu, the 'hour' value will be highlighted.
Using the cycle buttons to select and change the selected field's value.
1. To increase a field's value, press the UNWRAPPED cycle button. Holding the button down will
increase the value until released.
2. To decrease the value, press the WRAPPED cycle button.
3. To select the next field, press the RUBBER & PLASTICS cycle button.
4. To save changes and return to the regular operating mode, press the STOP button. The
changes will be saved automatically.
5. To quit without making changes, power the STATIM OFF.
>Language Setup
There are many languages available in the STATIM, which will display the operating information on
the LCD in the respective language chosen.
The default language in all units is ENGLISH, and on entering the language setup sub-menu,
alternative languages can be accessed as follows:
1. Press the UNWRAPPED cycle button to scroll to the next language (down).
2. Press the WRAPPED cycle button to scroll to the previous language (up).
Page 50
STAT IM 2000/2000S
STATIM 2000/2000S/2000 G4 Service Guide
96-108639 Rev 3.0
Service Guide