SciCan STATIM 2000 Service Manual page 254

12. Printer and Data Logger
10. Using the UNWRAPPED and WRAPPED buttons, scroll until the cursor is next to "Save and
Exit" and press the RUBBER & PLASTICS button, which will now take you out of the user
menu and back to the operating menu and will save your changes.
The LCD display should now show the following:
"MSD NOT DETECTED"/"INSERT
MSD/FLASH"/"SELECT A CYCLE"
Messages "MSD NOT DETECTED", "INSERT MSD/FLASH" and "SELECT A CYCLE" will
rotate in sequence and not all appear at the same time.
Note: When printed or electronic records are being kept for future reference, it is important
to ensure the correct data is printed, and a check should be undertaken at this stage to
ensure that the date, time and unit number (where appropriate) are set before using a data
recording device. This may have been undertaken during installation, if not, refer to the user
manual or to this service manual's Chapter 13, "Using the service menu" for information on
resetting the time, date and unit number.
11. Power OFF the STATIM unit.
Connecting the Data Logger.
1. Connect the Data Logger to the power cable attached to the transformer supplied. Important
note: ensure that the plug is fully inserted in the socket on the data logger.
2. Attach the adaptor suitable for your regional power supply on to the main body of the
transformer. Plug in to the mains supply BUT DO NOT SWITCH ON AT THIS TIME.
3. Ensure that the STATIM unit is powered OFF.
4. Using the Null Modem Serial Cable DB9F – DB25M supplied, connect the Data Logger to the
STATIM unit and secure the cable.
5. Power the Data Logger ON.
6. Power the STATIM unit ON.
The LCD display should now show the following:
"MSD NOT DETECTED"/"INSERT
MSD/FLASH"/"SELECT A CYCLE"
Messages "MSD NOT DETECTED", "INSERT MSD/FLASH" and "SELECT A CYCLE" will
rotate in sequence and not all appear at the same time.
Page 252
HH:MM DD/MM/YYYY
HH:MM DD/MM/YYYY
STAT IM 2000/2000S
STATIM 2000/2000S/2000 G4 Service Guide
96-108639 Rev 3.0
Service Guide