SciCan STATIM 2000 Service Manual page 236

11. Steam Generator, Check Valve, Thermal Fuse and Pressure Relief Valve
6. Remove the two screws (23) from the steam generator bracket (24). Note: The steam generator
will still be attached to the PCB by the thermocouple lead (8).
7. Carefully cut the two cable ties closest to the steam generator that hold the thermocouple
leads together.
8. Gently lift and turn the steam generator assembly onto one side to expose the bottom of the
assembly. Be careful not to stress the thermocouple leads. (Min. bend radius - 3/16 inch / 5 mm).
9. Remove the small screw that attaches the steam generator bracket to the steam generator.
10. Disconnect the thermal fuse (4) from the lower power terminal on the steam generator. Note
the routing of the thermal fuse assembly between the bracket and spacing lugs on the bottom
of the steam generator.
11. Remove the thermal fuse.
26
14
11
9
10
15
1. Chamber thermocouple leads
2. Controller board
3. Flag terminal (See Figure 3)
4. Microswitch leads
5. Cable tie
6. Steam generator thermocouple
7. Chamber thermocouple
8. Reservoir sensor leads
9. High temperature rated cable tie
10. Compressor tube
11. Check valve
12. Steam generator outlet tube
compression nut
Page 234
24 6
16 27 20 (obscured)
STAT IM 2000/2000S
4 1 5 23
21 17 (obscured) 19 (obscured)
13. Steam generator outlet tube
14. Steam generator outlet fitting
15. Screws for item 16
16. Steam generator / bracket
assembly
17. Exhaust tube compression
nut (obscured)
18. Solenoid valve exhaust tube
19. Solenoid valve inlet fitting
(obscured)
20. Screws for item 21 (one
screw obscured)
STATIM 2000/2000S/2000 G4 Service Guide
96-108639 Rev 3.0
Figure 12
18
21. Solenoid valve / bracket
assembly
22. Probe bracket assembly
23. Cap screws with flat
washers
24. Probe bracket gasket (not
shown)
25. Compression nut for probe
inlet fitting
26. Armature
27. Probe inlet fitting
28. Armature ground wire
Service Guide
2
25
12
13
7
8
22
28