Vor Navigation (Nav) Mode - Honeywell PRIMUS 1000 Pilot's Manual

R
PRIMUS 1000 Integrated Avionics System

VOR Navigation (NAV) Mode

The VOR mode automatically intercepts, captures, and tracks a
selected VOR radial, using the selected navigation source displayed on
the coupled–side HSI. The navigation source displayed on the HSI is
selected with the NAV source buttons located on the display controller.
Table 6–1 describes the procedure for engaging the VOR NAV mode.
Step
1 Couple either flight director to the autopilot with the FD
transfer switch.
2 Tune the navigation receiver to the frequency of the VOR
in use.
Select NAV as the navigation source on the display
3
controller.
4 Set the course pointer on the HSI for the course to be
flown.
5 Set the heading bug on the HSI to the intercept heading for
the selected course.
6 Push the NAV button on the mode selector.
VOR NAV Mode Engagement Procedure
VOR INTERCEPT
To intercept a radial from outside the normal capture range, as shown
in Figure 6–3, push the NAV button on the mode selector. The HDG and
NAV buttons light.
Modes of Operation
6-4
Procedure
Table 6–1
VOR NAV Mode Radial Intercept
Figure 6–3
A28–1146–134
REV 1 Jan/03