Parameter Window - Automatic Control (Multi-Level) - ABB i-bus KNX FCL/S 1.6.1.1 Product Manual

®
ABB i-bus KNX
Start-up
3.2.2.1.2

Parameter window - Automatic control (Multi-level)

This is the parameter window where you define the threshold values for switchover of the fan speed. Limi-
tations can also be enabled here.
This parameter window is visible if the Enable automatic operation parameter in
(Multi-level), p.21 is set to Yes.
When automatic operation is enabled, it is active after a download or an ETS reset.
When you activate a communication object in the Direct operation parameter window, automatic operation
stops immediately. You can only reactivate it via the Automatic ON/OFF communication object.
Important
The device evaluates threshold values in ascending order, i.e. first it checks the threshold value for Off -
> Fan speed 1, then Fan speed 1 -> Fan speed 2, and so on.
Proper functionality is only assured if the threshold value for OFF -> Fan speed 1 is less than that for
Fan speed 1 -> Fan speed 2 and this is less than Fan speed 2 -> Fan speed 3, etc.
Object value "Automatic On/Off"
switch on to the automatic
Options:
This parameter defines how to react to a telegram.

1: Automatic is activated by a telegram with value 1.

0: Automatic is activated by a telegram with value 0.
30 2CDC508116D0203 | FCL/S x.6.1.1
1
0
Parameter window A: Fan