Checking And Replacing The Rear Wheel Pulley; Assembling The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha Star XVS13AA(C) 2011 Service Manual

EAS22130
CHECKING AND REPLACING THE REAR
WHEEL PULLEY
1. Check:
• Rear wheel pulley
Surface plating has come off → Replace the
rear wheel pulley.
Bent teeth → Replace the rear wheel pulley.
2. Replace:
• Rear wheel pulley
M MMM M MMM M M MMM M M MMM M
a. Remove the self-locking nuts and the rear
wheel pulley.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact the
pulley.
c. Install the new rear wheel pulley.
Rear wheel pulley self-locking
nut
95 Nm (9.5 m·kg, 68 ft·lb)
TIP
Tighten the self-locking nuts in stages and in a
crisscross pattern.
L LLL L LLL L L LLL L L LLL L
EAS22140

ASSEMBLING THE REAR WHEEL

1. Install:
New
• Wheel bearings
• Oil seals New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-16.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
M MMM M M MMM M MMM
L LLL L L LLL L LLL
4-28
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-16.
EAS28770
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Lubricate:
• Rear wheel axle
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Rear brake disc
Rear brake disc bolt (for
XVS13AA(C)/XVS13CTA(C))
23 Nm (2.3 m·kg, 17 ft·lb)
LOCTITE®
Rear brake disc bolt (for
XVS13CA(C))
18 Nm (1.8 m·kg, 13 ft·lb)
LOCTITE®
TIP
• Apply locking agent (LOCTITE®) to the
threads of the brake disc bolts.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
LT
3. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-51.
4. Install:
• Rear wheel axle
• Washer
• Rear wheel axle nut
TIP
Temporarily tighten the wheel axle nut.
REAR WHEEL