1. Intake air pressure sensor hose
2. Front cylinder resonator hose
3. Resonator hose joint
4. Rear cylinder resonator hose
5. Canister purge hose (California only)
A. Install the intake air pressure sensor hose with its
green paint mark facing to the left.
B. Fasten the intake air pressure sensor hose to the
resonator hose joint with the holder. Be sure to
route the intake air pressure sensor hose to the left
of the front cylinder resonator hose and to the right
of the rear cylinder resonator hose.
C. Fasten the canister purge hose with the holder at
the location shown in the illustration. Fasten the
hose only, not the hose protector. (California only)
D. Route the canister purge hose to the right of the
frame. (California only)
E. Position the intake air pressure sensor hose below
and to the left of the resonator hose joint.
CABLE ROUTING (for XVS13CA(C))
2-100