Yamaha Star XVS13AA(C) 2011 Service Manual page 14

Trip F→ Trip 1 → Trip 2 → Clock → Odo → Trip
F
TIP
Push the " " side of the "SELECT" switch to
switch the display in the reverse order.
To reset a tripmeter, select it by pushing the "
or " " side of the "SELECT" switch, and then
push the "RESET" switch for at least one sec-
ond. If you do not reset the fuel reserve tripmeter
manually, it will reset itself automatically, and the
display will return to the prior mode after refuel-
ing and traveling 5 km (3 mi).
To set the clock:
1
1. Clock
1. Push the " " or "
switch to change the display to the clock
mode.
2. Push the " " side of the "SELECT" switch
and the "RESET" switch together for at least
two seconds.
3. When the hour digits start flashing, push the
" " or " " side of the "SELECT" switch to
set the hours.
4. Push the "RESET" switch, and the minute
digits will start flashing.
5. Push the " " or "
switch to set the minutes.
6. Push the "RESET" switch and then release it
to start the clock.
"
" side of the "SELECT"
" side of the "SELECT"
Self-diagnosis device
1
1. Fault code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are not working correctly,
the engine trouble warning light will come on,
and then the odometer/tripmeter/clock display
will indicate a two-digit fault code.
If the odometer/tripmeter/clock display indicates
any fault codes, note the code number, and then
check the vehicle. Refer to "FUEL INJECTION
SYSTEM" on page 8-45.
ECA3D8A003
NOTICE
If the display indicates a fault code, the vehi-
cle should be checked as soon as possible
in order to avoid engine damage.
Brightness control mode
1
1. Speedometer panel
2. Brightness level
This function allows you to adjust the brightness
of the speedometer panel to suit the outside
lighting conditions.
To set the brightness:
1-5
FEATURES
2