Yamaha Star XVS13AA(C) 2011 Service Manual page 16

TIP
Push the "RESET" switch for less than one sec-
ond to display the clock for five seconds, regard-
less of the currently selected display mode.
If the fuel level warning light comes on, the dis-
play will automatically change to the fuel reserve
tripmeter mode "Trip F" and start counting the
distance traveled from that point. In that case,
push the "SELECT" switch to change the display
between the various tripmeter, odometer, fuel
meter, and clock modes in the following order:
Trip F → Trip 1 → Trip 2 → Fuel meter → Clock
→ Odo → Trip F
To reset a tripmeter, select it by pushing the "SE-
LECT" switch, and then push the "RESET"
switch for at least one second. If you do not reset
the fuel reserve tripmeter manually, it will reset
itself automatically, and the display will return to
the prior mode after refueling and traveling 5 km
(3 mi).
Fuel meter
1.
1
2
1. Fuel meter
2. Segment
The fuel meter indicates the amount of fuel in
the fuel tank. The display segments of the
fuel meter disappear towards "E" (Empty) as
the fuel level decreases. When the fuel meter
changes from two segments to only one seg-
ment, approximately 5.0 L (1.32 US gal, 1.1
Imp.gal) of fuel remains in the fuel tank. Be
sure to refuel as soon as possible.
TIP
If the display is showing another function when
this occurs, the display will automatically change
to the fuel meter mode.
The fuel level warning light comes on and the
display switches to the fuel reserve tripmeter
mode "Trip F" when the fuel level is very low.
Refuel as soon as possible to avoid running
out of fuel.
To set the clock
1
1. Clock
1. Push the "SELECT" switch to change the dis-
play to the clock mode.
2. Push the "SELECT" and "RESET" switches
together for at least three seconds.
3. When the hour digits start flashing, push the
"SELECT" switch to set the hours.
4. Push the "RESET" switch, and the minute
digits will start flashing.
5. Push the "SELECT" switch to set the min-
utes.
6. Push the "RESET" switch and then release it
to start the clock.
Self-diagnosis device
1
1. Fault code display
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If a problem is detected in any of those circuits,
the engine trouble warning light will come on and
the display will indicate a fault code.
If the display indicates any fault codes, note the
code number, and then check the vehicle. Refer
to "FUEL INJECTION SYSTEM" on page 8-45.
ECA27D1003
NOTICE
If the display indicates a fault code, the vehi-
cle should be checked as soon as possible
in order to avoid engine damage.
1-7
FEATURES