Yamaha Star XVS13AA(C) 2011 Service Manual page 129

1. Intake air pressure sensor
2. Intake air pressure sensor hose
3. Front cylinder resonator hose
4. Canister purge hose (California only)
5. Throttle body
6. Rear cylinder resonator hose
7. Thermostat cover
A. Route the intake air pressure sensor hose
between the frame and the thermostat cover.
B. Point the ends of the hose clamp inward.
C. Install the canister purge hose with its green paint
mark facing upward. (California only)
D. Point the ends of the hose clamp forward. Position
the hose clamp over the green paint mark on the
canister purge hose. (California only)
E. 2–4 mm (0.08–0.16 in) (California only)
F. Point the ends of the hose clamp outward.
G. Align the projections on the intake manifold joints
with the slots in the intake manifold joint clamps.
H. Point the ends of the hose clamp outward.
I. 0–1 mm (0–0.04 in)
J. Install the intake air pressure sensor hose onto the
hose fitting of the throttle body with its green paint
mark facing to the right. Make sure that the hose
contacts the throttle body.
CABLE ROUTING (for XVS13CA(C))
2-102