Yamaha Star XVS13AA(C) 2011 Service Manual page 119

1. Clutch cable
2. Left handlebar switch lead
3. Meter assembly lead
4. Front cylinder spark plug lead
5. Coolant temperature sensor lead
6. Front cylinder injector lead
7. Fuel pipe
8. ISC (idle speed control) unit lead
9. Rear cylinder injector lead
10. Intake air pressure sensor hose
11. Starter motor lead
12. Front brake hose
A. Secure the plastic locking tie by inserting the
projection on the tie into the hole in the bracket,
and then fasten the meter assembly lead, clutch
cable, and left handlebar switch lead with the tie.
Align the tape on the meter assembly lead and left
handlebar switch lead with the plastic locking tie.
Cut off the excess end of the plastic locking tie so
that the cut end does not protrude past with the
edge of the bracket.
B. Route the left handlebar switch lead and meter
assembly lead under the bracket as shown in the
illustration.
C. Insert the projection on each left handlebar switch
coupler into the hole in the bracket.
D. Route the left handlebar switch lead under the fuel
tank bracket.
E. Route the front cylinder spark plug lead to the
outside of the left handlebar switch lead.
F. Route the clutch cable to the inside of the leads.
G. To right side of vehicle
H. Route the front cylinder injector lead to the inside
of the fuel pipe.
I. Route the ISC (idle speed control) unit lead to the
inside of the coolant temperature sensor lead and
fuel pipe, and to the outside of the front cylinder
injector lead.
J. To ISC (idle speed control) unit
K. Route the rear cylinder injector lead to the outside
of the clutch cable, and to the inside of the
thermostat cover.
L. Route the intake air pressure sensor hose to the
inside of the clutch cable.
M. Fasten the starter motor lead at the gray tape to
the engine mounting boss with a plastic locking tie.
Make sure that the starter motor lead does not
contact the engine bracket on the frame. Cut off
the excess end of the plastic locking tie.
N. Face the catch of each holder outward.
O. Route the front brake hose through the guide.
P. Fasten the front brake hose with the holder.
CABLE ROUTING (for XVS13CA(C))
2-92