b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be less than 3 mm (0.12 in) of
clearance "a" between the handlebar grip and
left handlebar switch.
1
L
LLL
L LLL
L
L LLL
L
L LLL
L
7. Install:
• Throttle grip "1"
• Throttle cables "2"
• Right handlebar switch "3"
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
1
2
a
3
8. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder "2"
Front brake master cylinder hold-
er bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
TIP
• Install the front brake master cylinder holder
with the "UP" mark facing up.
a
L LLL
L
L LLL
L
LLL
3
b
4-64
• Align the end of the front brake master cylinder
holder with the punch mark "a" on the handle-
bar.
• First, tighten the upper bolt, then the lower bolt.
1
a
2
9. Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-13.
Clutch lever free play
5.0–10.0 mm (0.20–0.39 in)
10.Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-8.
Throttle cable free play
4.0–6.0 mm (0.16–0.24 in)
HANDLEBAR