Table of Contents
Advertisement
1. Coolant reservoir hose
2. Clutch cable
3. Lean angle sensor
4. Fuel hose
5. Brake fluid reservoir hose
6. Coolant reservoir breather hose
7. Wire harness
8. O
sensor
2
9. O
sensor lead
2
A. Be sure not to pinch the O
installing the coolant reservoir cap cover.
B. Secure the holder by inserting the projection on
the holder into the hole in the bracket, and then
fasten the lean angle sensor lead and wire harness
with the holder.
C. To O
sensor
2
D. To horn and rear brake light switch
E. Route the clutch cable through the guide.
F. To clutch cover
G. To coolant reservoir
H. To fuel pump
I.
Install the fuel hose with its white paint mark facing
forward.
J. Secure the holder by inserting the projection on
the holder into the hole in the frame, and then
fasten the wire harness with the holder.
K. Fasten the O
sensor lead to the coolant reservoir
2
cover with the plastic band.
L. Insert the projection on the O
the hole in the coolant reservoir cover.
M. Route the O
sensor lead over the brake fluid
2
reservoir hose.
N. To wire harness
O. Position the end of the plastic band to the inside of
the coolant reservoir cover.
CABLE ROUTING (for XVS13CA(C))
sensor lead when
2
sensor coupler into
2
2-88
Advertisement
Chapters
Table of Contents
