Yamaha Star XVS13AA(C) 2011 Service Manual page 87

CABLE ROUTING (for XVS13AA(C)/XVS13CTA(C))
1. Wire harness
2. Coolant reservoir hose
3. Rear cylinder spark plug cap
4. Clutch cable
5. Throttle position sensor lead
6. Intake air pressure sensor hose
7. Right handlebar switch couplers
8. Thermostat cover inlet hose
9. Right handlebar switch lead
10. Throttle cable (accelerator cable)
11. Throttle cable (decelerator cable)
12. Front brake hose
13. Radiator inlet hose
14. Starter motor lead
15. Horn
16. Rear brake light switch
17. Resonator hose joint
18. Fuel tank
19. Horn lead
20. Rear brake light switch lead
21. Rear brake hose
22. Brake fluid reservoir hose
A. Fasten the clutch cable and coolant reservoir hose
with the holder, making sure to position the holder
– –
15 20 mm (0.59 0.79 in) to the rear of the holder
(indicated with an asterisk in the illustration) that is
attached to the frame.
B. Fasten the clutch cable with the plastic band. Point
the end of the plastic band inward.
C. Fasten the resonator hose joint, wire harness, and
right handlebar switch lead with the plastic band.
D. Make sure that the throttle cable (decelerator
cable) does not contact the frame, the throttle
cable (accelerator cable) does not contact the rear
cylinder thermostat inlet hose, and the throttle
cables do not contact each other.
E. Fasten the wire harness by sliding the plastic
holder on the wire harness onto the stud on the
frame.
F. Route the throttle cables to the inside of the
thermostat cover inlet hose and under the wire
harness, making sure that the cables are not
pinched by the harness.
G. Route the rear cylinder spark plug lead to the
inside of the intake air pressure sensor hose and
front cylinder resonator hose.
H. Connect the longer horn lead to the upper horn
terminal and connect the shorter horn lead to the
lower horn terminal.
I. Fasten the horn lead and rear brake light switch
lead with a plastic locking tie, and then cut off the
excess end of the tie.
J. Route the horn lead and rear brake light switch
lead to the inside of the engine bracket on the
down tube.
K. Fasten the right handlebar switch lead at the tape
with the plastic band, making sure to install the
band on the lead's protective sleeve, not the lead
itself.
L. Position the buckle of the plastic band under the
resonator hose joint, making sure to point the end
of the band inward. The end of the plastic band
may be positioned above or below the intake air
pressure sensor hose.
M. Be sure to install the throttle cable (decelerator
cable), identified by the longer nut, on the outer
side of the throttle cable pulley.
N. Route the horn lead and rear brake light switch
lead over the blind plug.
2-60