Table of Contents
Advertisement
4. Tighten:
• Connecting rod nuts
M
MMM
M MMM
M
M MMM
M
M MMM
M
EWA3D81005
WARNING
• Replace the connecting rod bolts and nuts
with new ones.
• Clean the connecting rod bolts.
TIP
Tighten the connecting rod bolts using the fol-
lowing procedure.
a. Tighten the connecting rod bolts to specifica-
tion with a torque wrench.
Connecting rod bolt (1st)
15 Nm (1.5 m·kg, 11 ft·lb)
b. Put a mark "1" on the corner of the connecting
rod bolt "2" and the connecting rod cap "3".
c. Tighten the connecting rod bolts further to
reach the specified angle 125–135°.
Connecting rod bolt (final)
Specified angle 125–135°
EWA3D81006
WARNING
When a bolt is tightened more than the spec-
ified angle, do not loosen and then retighten
it.
Replace the bolt with a new one and perform
the procedure again.
M MMM
M
M MMM
M
MMM
5-87
ECA3D81012
NOTICE
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS26210
INSTALLING THE CRANKSHAFT
ASSEMBLY
1. Install:
• Crankshaft assembly
ECA3D81013
NOTICE
To avoid scratching the crankshaft and to
ease the installation procedure, lubricate
each bearing with engine oil.
TIP
Align the right connecting rod with the rear cylin-
der sleeve hole.
CRANKSHAFT
L LLL
L
L LLL
L
LLL
Advertisement
Chapters
Table of Contents
