Installing The Handlebar (For Xvs13Ca(C)) - Yamaha Star XVS13AA(C) 2011 Service Manual

EAS27D1019
INSTALLING THE HANDLEBAR (for
XVS13CA(C))
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Rubber damper "1"
• Handlebar
TIP
• Before affixing the damper, remove any dust
and grease from the area where the damper
will be affixed.
• Align the damper with the edges "a" of the
meter assembly bracket on the handlebar.
• Make sure that the meter assembly lead, left
handlebar switch lead, and right handlebar
switch lead are routed properly. Refer to "CA-
BLE ROUTING (for XVS13CA(C))" on page
2-79.
Handlebar nut
32 Nm (3.2 m·kg, 23 ft·lb)
a
3. Affix:
• Rubber damper "1"
(to the meter assembly cover)
TIP
Before affixing the dampers to the bottom of the
meter assembly cover, remove any dust and
grease from the areas where the dampers will
be affixed.
1
4-63
a
a
a. 0.5–1 mm (0.02–0.04 in)
4. Install:
• Clutch lever "1"
• Clutch cable "2"
Clutch lever bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
TIP
Align the mating surfaces of the clutch lever with
the punch mark "a" on the handlebar.
5. Install:
• Left handlebar switch "1"
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
1
a
6. Install:
• Handlebar grip "1"
M MMM M MMM M M MMM M M MMM M
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
HANDLEBAR
1
1
2
a
b
M MMM M M MMM M MMM