Yamaha Star XVS13AA(C) 2011 Service Manual page 99

CABLE ROUTING (for XVS13AA(C)/XVS13CTA(C))
1. Wire harness
2. Coolant reservoir hose
3. Throttle cable (accelerator cable)
4. Throttle cable (decelerator cable)
5. Intake air pressure sensor hose
6. Right handlebar switch couplers
7. Throttle position sensor
8. Rear cylinder spark plug lead
9. Air vent hose
10. Fuel cock hose
11. Negative battery lead terminal
12. Battery
13. Positive battery lead terminal
14. Tail/brake light wire harness
15. ECU (engine control unit)
16. Main fuse
17. Fuse box
18. Starter relay
19. Sub-wire harness couplers
20. Rear cylinder ignition coil
21. Left handlebar switch couplers
22. Intake air pressure sensor coupler
23. Front cylinder spark plug lead
24. Sidestand switch coupler
25. Oil level switch coupler
26. Radiator fan motor coupler
27. Clutch cable
28. Left handlebar switch lead
29. Sub-wire harness
30. Starter motor lead
31. Lean angle sensor
32. Positive battery lead
33. Relay unit
A. Be sure to route the clutch cable over any cable,
lead, pipe, or hose that it crosses in the area
shown in the illustration.
B. Fasten the coolant reservoir hose to the plastic
locking tie with the clamp.
C. Fasten the wire harness and sub-wire harness with
a plastic locking tie. Point the end of the plastic
locking tie downward, to the inside of the rear
cylinder right cover.
D. To fuel sender
E. Insert the projections on the wire harness holders
completely into the holes in the frame.
F. Route the fuel sender lead under the air vent hose.
G. Route the negative battery lead between the
battery and the tool kit tray, and then fasten the tray
and lead with the battery cover band.
H. To tail/brake light assembly
I. Route the tail/brake light wire harness through the
guides on the tool kit tray.
J. Slide the rubber cover over the neutral switch
coupler and speed sensor coupler, making sure
that the couplers are covered completely.
K. Fasten the wire harness, sub-wire harness, left
handlebar switch lead, and clutch cable with a
plastic locking tie, making sure that the tie does not
contact the protective tape on the frame.
L. Fasten the wire harness and right handlebar
switch lead to the frame with a plastic locking tie.
Position the end of the plastic locking tie to the
inside of the front cylinder thermostat inlet hose.
M. Route the rear cylinder spark plug lead under the
U-shaped fuel pipe.
N. Make sure not to route the positive battery lead on
top of the relay unit.
O. Install the relay unit completely onto the tab on the
battery box.
P. Install the fuse box completely onto the tab on the
battery box.
Q. Install the main fuse completely onto the tab on the
battery box.
2-72