Emerson Rosemount 3308A Reference Manual page 83

Reference Manual
00809-0100-4308, Rev CA
Verify by Gateway
To use the Wireless Gateway's integrated web interface, navigate to the Explorer > Status page as shown
in Figure
properly.
Locate the device in question and verify all status indicators are good (green). It may take several
minutes for the device to join the network and be seen on the Gateway's integrated web interface.
Figure 4-10. Wireless Gateway Explorer Status Page
Verify with Field Communicator
Connect the Field Communicator as shown in
Removing the power module may cause the device to drop off the network.
Note
In order to communicate with a Field Communicator, the device must be powered by the power module.
To verify the device has joined the network:
1. Select Service Tools > Communications.
2. Select Join Status.
Configuration
PRELIMINARY
4-10. This page shows whether the device has joined the network and if it is communicating
Figure 4-5 on page 66. Do not remove the power module.
Configuration
August 2017
71