Join Device To Wireless Network; Power Up The Wireless Device - Emerson Rosemount 3308A Reference Manual

Configuration
August 2017
4.6

Join device to wireless network

4.6.1

Power up the wireless device

Make sure that the Wireless Gateway is installed and functioning properly before any wireless field
devices are powered. See
install the power module.
Wireless devices should be powered up in order of proximity from the Gateway, beginning with the
closest. This will result in a simpler and faster network installation.
Enable Active Advertising on the Gateway to ensure that new devices join the network faster. For more
information, see the Gateway
Startup screen sequence
The following screens will be displayed in sequence when the power module is first connected to the
Rosemount 3308 Series Transmitter.
Figure 4-4. Startup Screen Sequence
1. All Segments ON
Used to visually determine if there
are any bad segments on the
device display.
4. Software Revision
Used to determine Device
Software Revision.
64
PRELIMINARY
"Install the power module" on page 55
Reference Manual.
2. Device Identification
Identification string used to
determine the Device Type.
5. Device Information: Status
This screen will only appear if there
is a critical error which may prevent
the device from operating correctly.
Check additional status screens for
more information about failure
source, refer to "Diagnostic button
screen sequence" on page
Reference Manual
00809-0100-4308, Rev CA
for further information on how to
3. Device Information: Tag
User entered tag, 8 characters
long. This screen will not display if
all characters are blank.
6. Primary Variable
Measurement value of mapped
Primary Variable.
78.
Configuration