Configuring Rip Route Control; Configuring An Additional Routing Metric - HP 6125XLG Configuration Manual

Step
3. Specify a global RIP version.
4. Return to system view.
5. Enter interface view.
6. Specify a RIP version for the
interface.

Configuring RIP route control

Before you configure RIP route control, complete the following tasks:
Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
•
• Configure basic RIP.

Configuring an additional routing metric

An additional routing metric (hop count) can be added to the metric of an inbound or outbound RIP
route.
An outbound additional metric is added to the metric of a sent route, and it does not change the route's
metric in the routing table.
An inbound additional metric is added to the metric of a received route before the route is added into the
routing table, and the route's metric is changed. If the sum of the additional metric and the original metric
is greater than 16, the metric of the route is 16.
To configure additional routing metrics:
Step
1. Enter system view.
2. Enter interface view.
3. Specify an inbound
additional routing metric.
4. Specify an outbound
additional routing metric.
Command
version { 1 | 2 }
quit
interface interface-type
interface-number
rip version { 1 | 2 [ broadcast |
multicast ] }
Command
system-view
interface interface-type
interface-number
rip metricin [ route-policy
route-policy-name ] value
rip metricout [ route-policy
route-policy-name ] value
24
Remarks
By default, no global version is
specified, and an interface sends
RIPv1 broadcasts, and can receive
RIPv1 broadcasts and unicasts,
and RIPv2 broadcasts, multicasts,
and unicasts.
N/A
N/A
By default, no interface-specific RIP
version is specified, and the
interface sends RIPv1 broadcasts,
and can receive RIPv1 broadcasts
and unicasts, and RIPv2
broadcasts, multicasts, and
unicasts.
Remarks
N/A
N/A
The default setting is 0.
The default setting is 1.