Troubleshooting: Disable 'Access Control' And Ipsec (Océ Plotwave 500 And Plotwave 340/360 Systems) - Canon Oce PlotWave 300 Administration Manual

Troubleshooting: Disable 'Access control' and IPsec (Océ PlotWave 500 and PlotWave 340/360 systems)
Troubleshooting: Disable 'Access control' and IPsec (Océ PlotWave 500 and
PlotWave 340/360 systems)
Introduction
In the following case:
• Access control and IPsec have been enabled without any station defined
and
• The communication between the controller and the host stations fails
Any remote connection to Océ Express WebTools is impossible. The system is unreachable.
Then, use the emergency procedure to disable IPsec and Access control via the printer user
panel.
Disable Access control on the printer user panel
Procedure
1. On the user panel, tap the upper right corner, to display the menu
2. Select 'Security'
3. For Océ PlotWave 500, enter the System administrator (or Power user) password
For Océ PlotWave 340/360 enter the 'Password to change networks settings' if set.
132 Chapter 3 - Security on Océ PlotWave 500 and PlotWave 340/360