Canon Oce PlotWave 300 Administration Manual page 53

Troubleshooting: emergency procedure to disable IPsec
Introduction
In the following case:
• IPsec is enabled and activated on the printer/scanner controller
and
• The 'Failsafe mode' is disabled
and
• The communication between the controller and the IPsec stations fails
You cannot open remotely Océ Express WebTools to change the settings. The system is
unreachable.
Then you can use the emergency procedure to disable IPsec:
• Via the printer User panel on the printer/scanner system, for Océ PlotWave 300/350 and Océ
ColorWave 300
• Via Océ Express WebTools on the printer controller monitor for Océ PlotWave 900 R1.2 and
higher 1.x
Disable IPsec on the printer user panel (Océ PlotWave 300/350 and Océ ColorWave 300)
Procedure
1. On the printer printer user panel, click on 'System'
2. Select 'Setup'
3. Roll down to the Security item and open the Security menu
The status is 'IPsec is enabled'
4. Click 'Next' several times to open the IPsec window
NOTE
Enter the password if required (Password to change the security level - depends on the
configuration of the access to the Security menu).
Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300
Troubleshooting: emergency procedure to disable IPsec
53