Canon Oce PlotWave 300 Administration Manual page 179

2. Below the 'User access mode' section, click 'Validate the configuration'.
3. Leave the 'User name' field empty and enter the PIN if it is required in the user access settings.
4. Click 'OK'.
A report is generated:
5. Check there is no red cross icon in the report.
If there is a red cross, solve the issue or check the solutions in the troubleshooting section, see
Troubleshooting of authentication by smart card on page
Authentication on the user panel
Introduction
Insert the smart card into the card reader.
• The authentication is automatic when the smart card contains a valid user name (and no
password is needed).
• A login window is displayed when the authentication with the smart card requires a PIN. Enter
the PIN in the password field.
• A login window is displayed when there is more than one user registered into the smart card.
Select the user name and enter the PIN in the password field
Chapter 4 - Security on Océ PlotWave 345/365 and Océ PlotWave 450/550
Authentication on the user panel
180.
179