Canon Oce PlotWave 300 Administration Manual page 29

Before you begin
The System Administrator or a Power User can protect the security settings with a password.
When the protection is activated, you must type the password in the printer user panel before
you can change the security level.
Procedure
1. From the [HOME] screen select the [System] tab.
2. Select the [Setup] tab.
3. Use the scroll wheel to go to the [Security]([Configure settings]) wizard.
4. Open this section with the confirmation button.
5. The screen displays the security level and the active network access options:
6. Two options are possible:
• Press the [Back] key in case you only want to check the security settings.
• Press the [Next >] key in case you want to adapt the security level.
Enter the password if requested and follow the wizard to adapt the security level.
Protect the security level by a password
Procedure
1. Open the Océ Express Webtools in a web browser (http://Printer IP address or hostname)
2. In the 'Preferences' tab, select 'System settings'
3. In the 'Printer Properties', goes to 'Password to change security level'
4. Click on the value to edit it
5. Log in as the System Administrator or as a Power User
6. Select 'New'
7. Type and re-type a numeric password
8. Confirm to activate the password.
Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300
Protect the security level by a password
29