Canon Oce PlotWave 300 Administration Manual page 85

6. Keep the other parameters as they are.
7. In the 'IPsec stations' section, click 'Edit'
8. Select '"IPsec station 1: Enable'
9. Enter the 'IPsec station 1: IP address' of the workstation
10. Create and enter the 'IPsec station 1: Preshared key' using the following policy:
• 256 characters maximum
• Any number [0-9]
• Any letter lowercase/upper-case [a-z][A-Z]
• the following special characters:
_ - ~
( ) =
NOTE
Write it down, this preshared key will be required during the IPsec configuration on the
workstation.
NOTE
IPsec can be used only with IPv4 (IP type set to 'IPv4 only' or 'IPV4 and IPv6 both
enabled').
In the Connectivity - Network adapter section, make sure 'IPv6 only' is NOT enabled
before you configure IPsec on the controller.
Chapter 2 - Security on Océ PlotWave 300/350, PlotWave 750, PlotWave 900 and ColorWave 300
! @ #
+ , .
Configure the IPsec settings in the Océ controller
$ % ^
; : [
* ? {
] / |
}
\
85