Canon Oce PlotWave 300 Administration Manual page 287

Purpose
Complete the IPsec configuration for a secure connection between the printer/copier system and
a workstation.
On the workstation, perform the 7 following actions:
Add the security snap-in on page 122
1-
Create the security policy on page 123
2-
Create the filter list on page 124
3-
Define the filter actions and security negotiation on page 126
4-
5- Define the security rule on page 127
Assign the security policy on page 129
6-
7- Customize the IPsec settings on page 130
NOTE
The procedure below shows the configuration steps on Windows server 2008 for an Océ
ColorWave 300 system.
The procedure is similar on other Operating Systems (Windows Server 2003, Windows XP,
Windows Vista, Windows 7) and for other Océ printers.
Troubleshooting: Disable 'Access control' and IPsec (Océ ColorWave 650/550
systems)
Introduction
In the following case:
• Access control is enabled and activated on the printer/scanner controller of Océ ColorWave
650/550 v2.3.1 and higher
and
• The communication between the controller and the host stations fails
You cannot open remotely Océ Express WebTools to change the settings. The system is
unreachable.
Then you can use the emergency procedure to disable Access control Via the printer user panel
on the printer/scanner system
Disable Access control on the printer user panel (Océ ColorWave 650/550)
Procedure
1. On the printer user panel, click on 'System'
Troubleshooting: Disable 'Access control' and IPsec (Océ ColorWave 650/550 systems)
Chapter 5 - Security on Océ ColorWave 550/600/650 (and Poster Printer) 287