Table of Contents
Advertisement
Install the TPM security rivet by pressing the rivet firmly into the system board.
10.
Install the GPU cage
11.
Install the SFF hot-plug drive cage.
12.
Install the shipping brackets and shipping plates.
13.
Install the server into the chassis
14.
Connect the peripheral cables.
15.
Power up the server (on page 14).
16.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
•
Do not save the recovery key/password on the encrypted hard drive.
Enabling the Trusted Platform Module
When prompted during the start-up sequence, access RBSU by pressing the F9 key.
1.
From the Main Menu, select Server Security.
2.
From the Server Security Menu, select Trusted Platform Module.
3.
From the Trusted Platform Module Menu, select TPM Functionality.
4.
Select Enable, and then press the Enter key to modify the TPM Functionality setting.
5.
Press the Esc key to exit the current menu, or press the F10 key to exit RBSU.
6.
Reboot the server.
7.
Enable the TPM in the OS. For OS-specific instructions, see the OS documentation.
8.
("Installing the server into the
chassis" on page 23).
Hardware options installation 69
Advertisement
Table of Contents
