Reset Hwtacacs Statistics - HP 3600 v2 Series Command Reference Manual

View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the primary HWTACACS authorization server, in dotted decimal notation. The
default is 0.0.0.0.
port-number: Service port number of the primary HWTACACS authorization server. It ranges from 1 to
65535 and defaults to 49.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN that the primary HWTACACS authorization
server belongs to, where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the server
is on the public network, do not specify this option.
Description
Use the primary authorization command to specify the primary HWTACACS authorization server.
Use the undo primary authorization command to remove the configuration.
By default, no primary HWTACACS authorization server is specified.
The IP addresses of the primary and secondary authorization servers must be different. Otherwise, the
configuration fails.
If the specified server resides on an MPLS VPN, specify the VPN by using the vpn-instance
vpn-instance-name option.
If you configure the command repeatedly, only the last configuration takes effect.
You can remove an authorization server only when it is not used by any active TCP connection to send
authorization packets. Removing an authorization server affects only authorization processes that occur
after the remove operation.
NOTE:
The VPN specified by this command takes precedence over the VPN specified for the HWTACACS
scheme.
Related commands: display hwtacacs and vpn-instance (HWTACACS scheme view).
Examples
# Configure the IP address and port number of the primary authorization server for HWTACACS scheme
hwt1 as 10.163.155.13 and 49.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49

reset hwtacacs statistics

Syntax
reset hwtacacs statistics { accounting | all | authentication | authorization } [ slot slot-number ]
86