Ipv6 Verify Source Max-Entries - HP 3600 v2 Series Command Reference Manual

Related commands: display ipv6 source binding.
Examples
# Configure dynamic IPv6 binding on Layer 2 Ethernet port Ethernet 1/0/1 to filter IPv6 packets based
on the source IPv6 address and MAC address.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] ipv6 verify source ipv6-address mac-address

ipv6 verify source max-entries

Syntax
ipv6 verify source max-entries number
undo ipv6 verify source max-entries
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
number: Maximum number of IPv6 source guard binding entries allowed on a port. The value is in the
range of 0 to 2048.
Description
Use the ipv6 verify source max-entries command to set the maximum number of static and dynamic IPv6
source guard binding entries on a port. When the number of IPv6 binding entries on a port reaches the
maximum, the port does not allowed new IPv6 binding entries any more.
Use the undo ipv6 verify source max-entries command to restore the default.
By default, the maximum number of IPv6 source guard binding entries allowed on a port is 2048.
If the maximum number of IPv6 binding entries to be configured is smaller than the number of existing
IPv6 binding entries on the port, the maximum number can be configured successfully and the existing
entries will not be affected. New IPv6 binding entries, however, cannot be added any more unless the
number of IPv6 binding entries on the port drops below the configured maximum.
Examples
# Set the maximum number of IPv6 source guard binding entries to 100 on port Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] ipv6 verify source max-entries 100
298