Dot1X - HP 3600 v2 Series Command Reference Manual

Field
EAP Success Packets
Fail Packets
Received EAPOL Start Packets
EAPOL LogOff Packets
EAP Response/Identity Packets
EAP Response/Challenge Packets
Error Packets
Authenticated user
Controlled User(s) amount

dot1x

Syntax
In system view:
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
In Ethernet interface view:
dot1x
undo dot1x
View
System view, Ethernet interface view
Default level
2: System level
Parameters
interface interface-list: Specifies a port list, which can contain multiple ports. The interface-list argument
is in the format of interface-list = { interface-type interface-number [ to interface-type interface-number ] }
& <1- 1 0>, where interface-type represents the port type, interface-number represents the port number,
and & <1- 1 0> means that you can provide up to 10 ports or port ranges. The start port number must be
smaller than the end number and the two ports must be of the same type.
Description
Use the dot1x command in system view to enable 802.1X globally.
Use the undo dot1x command in system view to disable 802.1X globally.
Use the dot1x interface command in system view or the dot1x command in interface view to enable
802.1X for specified ports.
Use the undo dot1x interface command in system view or the undo dot1x command in interface view to
disable 802.1X for specified ports.
By default, 802.1X is neither enabled globally nor enabled for any port.
Description
Number of sent EAP Success packets
Number of sent EAP-Failure packets
Number of received EAPOL-Start packets
Number of received EAPOL-LogOff packets
Number of received EAP-Response/Identity packets
Number of received EAP-Response/Challenge packets
Number of received error packets
User that has passed 802.1X authentication
Number of authenticated users on the port
104