Arp Rate-Limit Information - HP 3600 v2 Series Command Reference Manual

Parameters
disable: Disables ARP packet rate limit.
rate pps: Specifies the ARP packet rate in pps, in the range of 5 to 100.
drop: Discards the exceeded packets.
Description
Use the arp rate-limit command to configure or disable ARP packet rate limit on an interface.
Use the undo arp rate-limit command to restore the default.
By default, ARP packet rate limit is disabled.
Examples
# Specify the ARP packet rate on layer 2 Ethernet port Ethernet 1/0/1 as 50 pps, and exceeded packets
will be discarded.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] arp rate-limit rate 50 drop

arp rate-limit information

Syntax
arp rate-limit information interval seconds
undo arp rate-limit information
View
System view
Default level
2: System level
Parameters
interval seconds: Specifies the interval for sending trap and log messages when ARP packet rate exceeds
the threshold rate. The seconds argument ranges 1 to 86400, in seconds.
Description
Use the arp rate-limit information command to set the interval for sending trap and log messages when
ARP packet rate exceeds the threshold rate.
Use the undo arp rate-limit information command to restore the default.
By default, the interval is 60 seconds.
NOTE:
This command must work in cooperation with the arp rate-limit command.
Examples
# Configure the device to send trap and log messages every 120 seconds when ARP packet rate exceeds
the threshold rate.
<Sysname> system-view
[Sysname] arp rate-limit information interval 120
302