Distribute-List Out - Dell PowerConnect 7000 Series Reference Manual

integer — RIP route preference. (Range: 1-255)
•
Default Configuration
15 is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the route preference value of RIP in the router at
100.
console(config-router)#distance rip 100

distribute-list out

Use the distribute-list out command in Router RIP Configuration mode to
specify the access list to filter routes received from the source protocol. Use
the no form of the command to remove the access list from the specified
source protocol.
Syntax
distribute-list
no distribute-list
accesslistname — The name used to identify the existing ACL. The range
•
is 1-31 characters.
• ospf — Apply the specific access list when OSPF is the source protocol.
• static — Apply the specified access list when packets come through a static
route.
• connected — Apply the specified access list when packets come from a
directly connected route.
1248
Routing Information Protocol Commands
accesslistname
out {ospf | static | connected}
accesslistname
out {ospf | static | connected}