rtb: rtb-entryinfo...............Disabled
state-change:
all..............................Disabled
if state change..................Enabled
neighbor state change............Enabled
virtif state change..............Disabled
virtneighbor state change........Disabled
snmp-server community
Use the snmp-server community command in Global Configuration mode to
set up the community access string to permit access to the SNMP protocol.
To remove the specified community string, use the no form of this command.
Syntax
snmp-server community
ipaddress
]
no snmp-server community
Parameter Description
Parameter
string
ro
rw
su
ipaddress
view-name
string
{ro | rw | su} [view
string
Description
Permits access to the SNMP protocol. (Range: 1-20 characters)
Indicates read-only access.
Indicates read-write access.
Indicates SNMP administrator access.
Specifies the IP address of the management station. If no IP
address is specified, all management stations are permitted.
Specifies the name of a previously defined view. For
information on views, see the User Guidelines below. (Range: 1-
30 characters)
view-name
][ipaddress
SNMP Commands
1529