Show Sdm Prefer - Dell PowerConnect 7000 Series Reference Manual

Message Type
Error Completion
Message

show sdm prefer

Use the show sdm prefer command in Privileged EXEC mode to view the
currently active SDM template and its scaling parameters, or to view the
scaling parameters for an inactive template.
Syntax
show sdm prefer [dual-ipv4-and-ipv6 default|ipv4-routing {default|data-
center}]
Parameter Description
Parameter
dual-ipv4-and-ipv6
default
ipv4-routing default List the scaling parameters for the IPv4-only template
ipv4-routing data-
center
The following table explains the output parameters.
Parameter
ARP Entries
IPv4 Unicast Routes The maximum number of IPv4 unicast forwarding table entries.
IPv6 NDP Entries
IPv6 Unicast Routes The maximum number of IPv6 unicast forwarding table entries.
ECMP Next Hops
Message Description
None
Description
List the scaling parameters for the template supporting IPv4
and IPv6.
maximizing the number of unicast routes.
List the scaling parameters for the IPv4-only template
supporting more ECMP next hops.
Description
The maximum number of entries in the IPv4 Address
Resolution Protocol (ARP) cache for routing interfaces.
The maximum number of IPv6 Neighbor Discovery Protocol
(NDP) cache entries.
The maximum number of next hops that can be installed in the
IPv4 and IPv6 unicast forwarding tables.
SDM Templates Commands
1481