Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 342

CIR Admin
CIR Rule
PIR Admin
PIR Rule
CBS
Port-Id
Accounting
Remark Type
Page 366
Label
Default —Specifies the default dot1p value according to FC-Dot1p
marking map as defined in
ID 1 Definition, on page 61
Specifies the administrative Committed Information Rate (CIR)
parameters for the queue. The CIR defines the rate at which the
system prioritizes the queue over other queues competing for the
same bandwidth.
min — The operational CIR for the queue will be equal to or
greater than the administrative rate specified using the rate com-
mand.
max — The operational CIR for the queue will be equal to or
less than the administrative rate specified using the rate com-
mand.
closest — The operational CIR for the queue will be the rate
closest to the rate specified using the rate command without
exceeding the operational PIR.
Specifies the administrative Peak Information Rate (PIR)
parameters for the queue. The PIR defines the maximum rate
that the queue can transmit packets through the access port.
min — The operational PIR for the queue will be equal to or
greater than the administrative rate specified using the rate com-
mand.
max — The operational PIR for the queue will be equal to or
less than the administrative rate specified using the rate com-
mand.
closest — The operational PIR for the queue will be the rate
closest to the rate specified using the rate command.
def — Specifies that the CBS value reserved for the queue.
Specifies the physical port identifier that associates the access
egress QoS policy.
Specifies whether the accounting mode is packet-based or
frame-based.
Displays the type of remarking enabled. It can be "use-dot1p ",
"use-dscp" or "all"
Description (Continued)
Table 26, Default SAPAccess Egress Policy
if explicit values are not configured..
7210 SAS M OS Quality of Service Guide