Service Ingress Meter Selection Rules - Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual
Hide thumbs
Also See for 7210 SAS M OS:
- Service manual (952 pages) ,
- Configuration manual (558 pages) ,
- Interface configuration manual (347 pages)
Table of Contents
Advertisement
Starting with the above policy, if the user now executes the command "configure qos sap-ingress
<id> meter 11 multipoint create", the FC "be" continues to use meter "3" and the FC "af" uses
meter "11" for BUM traffic. In the above example, if the user were to execute "configure qos sap-
ingress <id> fc be no multicast-meter", then the default meter "11" is used for FC "be" too.
Example 3:
----------------------------------------------
configure> qos> sap-ingress 10 create
meter 1 create
exit
meter 3 create
exit
default-fc be
fc be
exit
exit
----------------------------------------------
On execution of the command "configure qos sap-ingress <id> meter 11 multipoint create", FC
"be" unknown-unicast traffic type will continue to use meter 3 and broadcast and multicast traffic
type will use meter "11".
In the above example, if initially a broadcast-meter was configured in the sap-ingress policy and
then followed by execution of the command "configure qos sap-ingress <id> meter 11
multipoint create", then FC be changes to use meter "11" for multicast traffic and broadcast
traffic continue to use meter "3" for unknown-unicast traffic and meter "3" for unicast traffic.
In the above example, if the user executes "configure qos sap-ingress <id> fc be no unknown-
meter", then meter "3" is used for all traffic types classified to FC "be". But, if the default meter
"11" is defined in the policy, then FC "be" uses meter "11" for BUM traffic.
Service Ingress Meter Selection Rules
The following are rules for meter selection by different traffic types under various configurations
for VPLS services:
•
Sample configuration:
*7210-SAS>config>qos# sap-ingress 1 create // Default policy
7210 SAS M OS Quality of Service Guide
meter 3
unknown-meter 3
In the default policy, only meter "1" is defined. All FC and all traffic types use meter "1"
by default. Meter "11" is not created by default and is not available for use.
Service Ingress QoS Policies
Page 233
Advertisement
Table of Contents
