Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 150

Network Ingress QoS Policy Commands
Network Ingress QoS Policy Commands
ingress
Syntax ingress
Context config>qos>network policy-id
This command is used to enter the CLI node that creates or edits policy entries that specify the lsp-
Description
exp value to forwarding class mapping for all MPLS packets.
When pre-marked packets ingress on a network port, the QoS treatment through the 7210 SAS-
based on the mapping defined under the current node.
default-action
default-action fc fc-name [profile {in | out}]
Syntax
Context config>qos>network>ingress
This command defines or edits the default action to be taken for packets that have an undefined
Description
LSP EXP or dot1p bits (for 7210 SAS-M in access uplink mode) bits set. The default-action
command specifies the forwarding class to which such packets are assigned.
Multiple default-action commands will overwrite each previous default-action command.
default-action fc be profile out
Default
fc fc-name — Specify the forwarding class name. All packets with LSP EXP or dot1p bits (for 7210 SAS-
Parameters
M in access uplink mode) bits that is not defined will be placed in this forwarding class.
Default
Values
profile {in | out} — All packets that are assigned to this forwarding class will be considered in or out of
profile based on this command. In case of congestion, on network ingress, the meter/policer supports
color-aware policing/metering. The value of the profile parameter is used to provide the color to the
meter. Value of 'in' indicates 'Green' color OR in-profile packet to the meter and value of 'out' indicates
'Yellow' color OR out-of-profile packet to the meter operating in color-aware mode. Based on the
configured meter rates, the final profile for the packet is determined. The final color is used for
subsequent processing of the packet in the system. On egress, in case of congestion, the in-profile
packets are preferentially queued over the out-of-profile packets. The profile can be specified in 3.0
release
Default
Values
Page 158
None, the fc name must be specified
be, l2, af, l1, h2, ef, h1, nc
None
in, out
7210 SAS M OS Quality of Service Guide