Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 208

Overview
----------------------------------------------
*7210-SAS>config>qos>sap-ingress$
All FCs in the SAP ingress policy use the default meter 1 (for all traffic types). If the command
"configure qos sap-ingress <id> meter 11 multipoint create" is executed, it attaches the default
meter "11" with all the FCs defined in the SAP ingress policy.
After this configuration, all the FCs in this policy use two meters, default meter "1" to meter
unicast traffic for all the FCs and meter "11" to meter BUM traffic for all the FCs. In this specific
example, since only default FC "be" is in use, the multipoint meter will be used to meter BUM
traffic associated with default FC "be".
After the change the policy is as displayed in the example below:
*7210-SAS>config>qos# sap-ingress 12
*7210-SAS>config>qos>sap-ingress$ info
----------------------------------------------
meter 11 multipoint create
----------------------------------------------
*7210-SAS>config>qos>sap-ingress$
Delete the multipoint meter "11" to remove all the FCs associated with the multicast-meter
(assuming all the FCs are using the default multicast meter and do not have any other multicast
meter explicitly configured). Execute the command "configure qos sap-ingress <id> no meter
11" , this disassociates meter "11" from the FCs and now the FCs use only meter "1" (if no other
meter configured explicitly).
Example 2:
*7210-SAS>config>qos# sap-ingress 12
*7210-SAS>config>qos>sap-ingress$ info
----------------------------------------------
configure> qos> sap-ingress 10 create
meter 1 create
exit
meter 3 create
exit
default-fc be
fc be
exit
fc af
exit
exit
----------------------------------------------
Page 232
exit
num-qos-classifiers 4
meter 1 create
exit
meter 3
multicast-meter 3
meter 3
7210 SAS M OS Quality of Service Guide