Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 157

lsp-exp-value — Specify the LSP EXP values to be associated with the forwarding class.
Parameters
Default
Values
fc fc-name — Enter this required parameter to specify the fc-name that the EXP bit pattern will be
associated with.
Default
Values
profile {in | out} — Enter this required parameter to indicate whether the LSP EXP value is the in-profile
or out-of-profile value. The profile CLI parameter in the network qos policy of type ip-interface is
deprecated.
When `no ldp-use-local-fc-enable' is set, the system will throw an warning and updates the associated
mpls-lsp-exp-profile-map policy with new profile value specified by the user.
When ldp-use-local-fc-enable is set, the system will error out the use of the profile command with an
error message.
Default
Values
adaptation-rule
Syntax adaptation-rule [cir adaptation-rule] [pir adaptation-rule]
no adaptation-rule
Context config>qos>network>ingress>meter
This command defines the method used by the system to derive the operational CIR and PIR
Description
settings when the meter is provisioned in hardware. For the CIR and PIR parameters, individually
the system attempts to find the best operational rate depending on the defined constraint.
The no form of the command removes any explicitly defined constraints used to derive the
operational CIR and PIR created by the application of the policy. When a specific adaptation-rule
is removed, the default constraints for rate and cir apply.
Default
adaptation-rule cir closest pir closest
adaptation-rule — Specifies the adaptation rule to be used while computing the operational CIR or PIR
Parameters
value.
pir — Defines the constraints enforced when adapting the PIR rate defined within the meter meter-id rate
command. The pir parameter requires a qualifier that defines the constraint used when deriving the
operational PIR for the meter. When the rate command is not specified, the default applies.
cir — Defines the constraints enforced when adapting the CIR rate defined within the meter meter-id rate
command. The cir parameter requires a qualifier that defines the constraint used when deriving the
operational CIR for the meter. When the cir parameter is not specified, the default constraint applies.
7210 SAS M OS Quality of Service Guide
None, the lsp-exp command must define a value.
0 to 7 (Decimal representation of three EXP bit field)
None, the lsp-exp command must define a fc-name.
be, l2, af, l1, h2, ef, h1, nc
None, the lsp-exp command must define a profile state.
in, out
Operational Commands
Page 165