Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 154

Network Ingress QoS Policy Commands
dscp
dscp dscp-name fc fc-name profile {in | out}
Syntax
no dscp
Context config>qos>network policy-id>ingress
This command creates a mapping between the DiffServ Code Point (DSCP) of the network ingress
Description
traffic and the forwarding class.
Ingress traffic that matches the specified DSCP will be assigned to the corresponding forwarding
class. Multiple commands can be entered to define the association of some or all sixty-four
DiffServ code points to the forwarding class. For undefined code points, packets are assigned to
the forwarding class specified under the default-action command.
The no form of this command removes the DiffServ code point to forwarding class association.
The default-action then applies to that code point value.
none
Default
dscp-name — The name of the DiffServ code point to be associated with the forwarding class. DiffServ code
Parameters
point can only be specified by its name and only an existing DiffServ code point can be specified. The
software provides names for the well known code points.
The system-defined names available are as follows. The system-defined names must be referenced as
all lower case exactly as shown in the first column in
Additional names to code point value associations can be added using the 'dscp-name dscp-name dscp-
value' command.
The actual mapping is being done on the dscp-value, not the dscp-name that references the dscp-value.
If a second dscp-name that references the same dscp-value is mapped within the policy, an error will
occur. The second name will not be accepted until the first name is removed.
Page 162
Table 36 and
7210 SAS M OS Quality of Service Guide
Table 37 below.