Table 26: Default Sapaccess Egress Policy Id 1 Definition - Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual

create — Keyword used to create an access-egress policy. The create keyword requirement can be enabled/
disabled in the environment>create context.
dot1p-in-profile
Syntax dot1p-in-profile dot1p-value
no dot1p-in-profile
Context config>qos>access-egress>fc
This command explicitly defines the egress IEEE 802.1P (Dot1p) bits marking for fc-name. All
Description
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined Dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect. The dot1p-in-
profile dot1p-value and dot1p-out-profile dot1p-value structure will add the capability to mark
Dot1p on an egress access port the in and out of profile packets. If the user has not explicitly
configured the FC-Dot1p map the marking of packets is still done according to
SAPAccess Egress Policy ID 1 Definition, on page
values using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-
Dot1P marking map as listed in
page 61.
Default
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If the
Parameters
not
command is executed multiple times with the same dot1p-value, the previous forwarding class and
enqueuing priority is completely overridden by the new parameters or defined to be inherited when a
forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
dot1p-out-profile
Syntax dot1p-out-profile dot1p-value
no dot1p-out-profile
Context config>qos>access-egress>fc
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. All
Description
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect. The dot1p-in-
profile dot1p-value and dot1p-out-profile dot1p-value commands will provide the capability to
7210 SAS M OS Quality of Service Guide
Table 26, Default SAPAccess Egress Policy ID 1 Definition, on
0 — 7
61. User can explicitly define the new Dot1P
Table 26, Default
Page 357